av-en-pipe   121 / 199



119 After cutting the pipe with specified length, put a gauge line along the perimeter of the pipe and put incision in the circumference direction spirally with a saw, etc. Heat evenly by a propane gas burner. Pinch the FRP layer with pliers, etc. and peel it off. Finish the FRP peeled part with a sand paper, etc., chamfer the tip 45「ェ, and apply adhesive evenly on the connection part of pipe and fitting. Insert into fitting using a lever block, etc. Remove the protruded adhesive from the connection end and weld. 1 2 3 4 5 6 Installation Procedure Installation Procedure