069 ENSAT (METAL INSERT) MOUNTING PROCEDURE DIAPHRAGM VALVE TYPE 14 15mm - 100mm TRUE UNION DIAPHRAGM VALVE TYPE 14 15mm - 50mm BALL VALVE TYPE 21, 21α 15mm - 50mm BALL VALVE TYPE 21 65mm - 100mm HOLD BOTTOM STAND PANEL BOTTOM STAND PANEL WASHER ENSAT BODY BOLT BEFORE INSTALLATION AFTER INSTALLATION WASHER WASHER NUT BODY BOTTOM STAND PANEL BODY BOTTOM STAND PANEL BOLT BEFORE INSTALLATION AFTER INSTALLATION At the bottom of the valve body, a "holed bottom stand" is provided which can be easily secured to a rack or panel only by inserting an Ensat. ★ Install the metal insert (Ensat) in the procedure below. Attach the Ensat at the end of special tool with the splitting groove facing downward. While ensuring that the center is aligned with the prepared hole from the front, back, right and left, screw the Ensat in to the predetermined depth. After the Ensat is screwed in completely, hold the nut with a spanner while turning the upper portion of the tool in the reverse direction. The tool will be freely movable and come out. Screw the Ensat in in a double nut fashion. After the Ensat is screwed in, hold the bolt and loosen the nut. The bolt will be freely movable and can be removed. When the Ensat is manually screwed in, the center alignment between the Ensat and the prepared hole is particularly important. Check that the Ensat is inserted perpendicular to the prepared hole while screwing it in. If it is tilted, do not turn the tool backward, but just put the Ensat in its correct position. Note that, when nearly half of the Ensat is once inserted, its position can no longer be corrected. NOTE For details of how to handle the Ensat mounting special tool, see the instruction manual provided by the Ensat manufacturer. (K.K.V.CORPORATION) APPLICABLE ENSAT (REFERENCE) SPEC. SCREW SIZE LENGTH (mm) ① M5 10 ② M6 14 ③ M8 15 ④ M12 22 SIZE (mm) 15 20 25 14DV ① ① ① 21BV ① ① ① SIZE (mm) 32 40 50 14DV ① ② ② 21BV ② ② ② SIZE (mm) 65 80 100 14DV ③ ④ ④ BOTTOM STAND MOUNTING PROCEDURE
